Pro-tools MB-105 User Manual

MB-105 BENDERINSTRUCTION SETPRO-TOOLS7616 INDUSTRIAL LANE TAMPA, FLORIDA 33637-6715813-986-9000 PHONE 813-985-6588 FAXwww.pro-tools.com

PAGE 10QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000BENDING INSTRUCTIONSSTEP 6INSTALL TUBING IN BENDER AS SHOWN AND COMPLETE THE LAST BEND.AT THI

PAGE 11QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000HELPFUL INFORMATIONTO MEASURE RADIUS:START AT IMAGINARY CENTEROF SLEEVE, MEASURE TO EDGEOF DI

PAGE 12QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000EXTENSION BAR USESSOME SMALL DIES ARE TOO SMALL TO DRILL DRIVE HOLES.IN THIS CASE THE OUTSIDE

MB-105 BENDERWARRANTY POLICYALL PRODUCTS PRO-TOOLS MANUFACTURES CARRY A ONE YEARGUARANTEE AGAINST DEFECTS IN MATERIAL OR WORKMANSHIP. (PRODUCTSTHAT WE

FAQ’sQ: CAN THE BENDER BE CONVERTED TO HYDRAULIC?A: YES, WE CARRY A HYDRAULIC CONVERSION KIT THAT USES EITHER AIR ORELECTRIC.Q: WHAT IS THE BIGGEST T

PAGE 2QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000ASSEMBLY INSTRUCTIONSIN THE FOLLOWING INSTRUCTIONS WE WILL EXPLAIN THE ASSEMBLY OF THE BENDER.

PAGE 3QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000ASSEMBLY INSTRUCTIONSREMOVE 1” PIN FROM FRAMEASSEMBLY AND INSERT THROUGHEND HOLES (AS SHOWN)IN

PAGE 4QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000ASSEMBLY INSTRUCTIONSMAIN DIE INSTALLATIONREMOVE 1” PIN, LUBRICATE PIN ANDDIE SLEEVE, PLACE DI

PAGE5QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000ASSEMBLY INSTRUCTIONSTIGHTEN LOCKDOWN BOLT SO TUBEWILL NOT SLIP. BE CAREFUL NOT TOOVER-TIGHTEN

PAGE 6QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000BENDING INSTRUCTIONSENGAGE RATCHET AS SHOWN.PULL HANDLE IN DIRECTIONOF ARROW.FIG. ACONTINUE TO

PAGE 7QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000BENDING INSTRUCTIONSIN THE NEXT FEW PAGES, WE ARE GOING TO EXPLAIN A FEW THINGS ABOUT BENDERS

PAGE 8QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000BENDING INSTRUCTIONS12”24”36”1 ½”STEP 2TAKE THE 36” LONG PIECE OF TUBING AND MEASURE EXACTLY 1

PAGE 9QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000BENDING INSTRUCTIONSSTEP 4WE ARE NOW READY TO START A BENDING PROJECT. IN OUR EXAMPLE WE WILL